Mitsubishi MELSEC Q Series Programming Manual

6-118
BMOV(P)
6.4.6 Block 16-bit data transfers (BMOV(P))
BMOV(P)
Function
(1) Transfers in batch 16-bit data of n points from the device designated by to location n
points from the device designated by .
(2) Transfers can be accomplished even in cases where there is an overlap between the source
and destination device.
In the case of transmission to the smaller device number, transmission is from ; for
transmission to the larger device number, transmission is from + (n 1).
However, as shown in the example below, when transferring data from R to ZR, or from ZR
to R, the range to be transferred (source) and the range of destination must not overlap.
Transfer from R to R, or from ZR to ZR can be performed without any problem.
• ZR transfer range ((specified head No. of ZR) to (specified head No. of ZR + the number
of transfers -1))
• R transfer range ((specified head No. of R + file register block No. 32768) to (specified
head No. of R + file register block No. 32768 + the number of transfers -1))
: Head number of the devices where the data to be transferred is stored (BIN 16 bits)
: Head number of the devices of transfer destination (BIN 16 bits)
n : Number of transfers (BIN 16 bits)
Setting
Data
Internal Devices
R, ZR
J\
U\G
Zn
Constants
K, H
Other
Bit Word Bit Word
–– ––
–– ––
n ––
Basic
Process
High
performance
Redundant Universal LCPU
Command
Command
BMOVP
BMOV
n
n
BMOVP
BMOV
S D
S D
S
D
S
D
S
D
1234
H
5678
H
7FF0
H
6FFF
H
553F
H
+1
+2
+(n-2)
+(n-1)
+1
+2
+(n-2)
+(n-1)
n
1234
H
5678
H
7FF0
H
6FFF
H
553F
H
Block
transfer
B0b15 B0b15
S
D
S
S
S
S
D
D
D
D
n
S
S

Mitsubishi MELSEC Q Series Specifications

General

Brand	Mitsubishi
Model	MELSEC Q Series
Category	Controller
Language	English