Mitsubishi MELSEC Q Series Programming Manual

9-8
TO(P), DTO(P)
When a constant is specified to , writes the same data (value specified to ) to the area
of n3 words from the specified CPU shared memory.
(a) CPU shared memory addresses of the Basic model QCPU
(b) CPU shared memory address of the Universal model QCPU
*3
*2 : Usable as a user free area when auto refresh setting is not made.
In addition, even when auto refresh setting is made, the auto refresh send range or later is
usable as a user free area.
*3 : With Q02UCPU, data can not be written to the multiple CPU high speed transmission area.
(2) No processing is performed when the number of write points is 0.
(3) The number of write data varies depending on the target CPU module.
CPU module Number of Write Points
Basic model QCPU
1 to 320
Universal model QCPU
1 to 14336
S S
Constant
(When "5" is designated
for )
CPU shared memory
of host CPU (n1)
n2
S
5
5
5
5
n3 words
Writes the
same data to
the area of n3
words
5
S
0(0H)
96(60
H)
192(C0
H)
511(1FFH)
Host CPU operation information area
CPU shared memory address
System area
Host CPU refresh area
*2
User free area
Write designation
prohibited area
Write designation
permitted area
Host CPU operation information area
CPU shared memory address
System area
Host CPU refresh area
*2
User free area
Write designation
prohibited area
Write designation
permitted area
0(0
H)
512(200
H)
2048(800
H)
4096(1000
H)
10000(2710
H)
24335(5F0FH)
Unusable
Multiple CPU high speed
transmission area

Mitsubishi MELSEC Q Series Specifications

General

Brand	Mitsubishi
Model	MELSEC Q Series
Category	Controller
Language	English