EasyManua.ls Logo

Mitsubishi MELSEC Q Series - Page 95

Mitsubishi MELSEC Q Series
1296 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3-5
3
4
4
6
7
8
3.2 Designating Data
3.2.2 Using word (16 bits) data
(c) When destination (D) data is a word device
The word device for the destination becomes 0 following the bit designated by digit
designation at the source.
Fig 3.2 Ladder Example and Processing Conducted
(d) In cases where digit designation is made at the destination (D), the number of points
designated are used as the destination.
Bit devices below the number of points designated as digits do not change.
Fig 3.3 Ladder Example and Processing Conducted
(2) Using word devices
Word devices are designated in 1-point (16 bits) units.
1. When digit designation processing is conducted, a random value can be used
for the bit device initial device number.
2. Digit designation cannot be made for the direct access I/O (DX, DY).
Ladder Example Processing
With 16-Bit Instruction
Ladder Example Processing
When source (S) data is a numerical value
When source (S) data is a word device
0 0
X3
b0
D0
K1X0
b1b2b3
0000000000
X2 X1 X0
Filled with 0s
X3 X2 X1 X0
b15b4
X010
MOV K1X0 D0
Source (S) data
M15 M8
0 0 1 1 0 1 00
M7
M0
Not changed
K2M0
0 0
1 1
0
1
00
H1234
00
1
00
1
00
3
4
3
4
1 2
X010
MOV H1234 K2M0
Destination (D)
1
M107
0 0
1 1 1
0
1
M100
Not changed
K2M100
b15 b8
1 0 0 1 1 1 01
b7 b0
D0
10011101
M115 M108
X10
MOV D0 K2M100
Destination (D)
M0
MOV K100 D0
Designation of 1 point of word
device D0 (16 bits)

Table of Contents

Other manuals for Mitsubishi MELSEC Q Series

Related product manuals