Mitsubishi MELSEC Q Series Programming Manual

12-33
1
2
3
12
6
6
7
8
12.1 Error Code List 12.1.4 Error code list (2000 to 2999)
2200
[MISSING PARA.]
There is no parameter file in the drive specified as
valid parameter drive by the DIP switches.
■Collateral information
• Common information: Drive name
• Individual information:-
■Diagnostic Timing
• At power-on/At reset/STOP→RUN
• Check and correct the valid parameter drive
settings made by the DIP switches.
• Set the parameter file to the drive specified as
valid parameter drive by the DIP switches.
RUN:
off
ERR.:
Flicker
CPU Status:
Stop
Qn(H)
QnPH
QnPRH
[MISSING PARA.]
There is no parameter file at the program memory.
■Collateral information
• Common information: Drive name
• Individual information:-
■Diagnostic Timing
• At power-on/At reset/STOP→RUN
Set the parameter file to the program memory. Q00J/Q00/Q01
[MISSING PARA.]
Parameter file does not exist in all drives where
parameters will be valid.
■Collateral information
• Common information: Drive name
• Individual information:-
■Diagnostic Timing
• At power-on/At reset/STOP→RUN
Set a parameter file in a drive to be valid. QnU
[MISSING PARA.]
There is no parameter file in the program memory.
■Collateral information
• Common information: Drive name
• Individual information:-
■Diagnostic Timing
• At power-on/At reset/At writing to programmable
controller
Write parameter files to the program memory of
the CPU module.
LCPU
2210
[BOOT ERROR]
The contents of the boot file are incorrect.
■Collateral information
• Common information: Drive name
• Individual information:-
■Diagnostic Timing
• At power-on/At reset
Check the boot setting.
Q00J/Q00/Q01
*8
Qn(H)
QnPH
QnPRH
QnU
LCPU
2211
[BOOT ERROR]
File formatting is failed at a boot.
■Collateral information
• Common information: Drive name
• Individual information:-
■Diagnostic Timing
• At power-on/At reset
• Reboot.
• The cause is a hardware failure of the CPU
module. (Please consult your local Mitsubishi
representative, explaining a detailed
description of the problem.)
Qn(H)
QnPRH
QnU
LCPU
2213
[BOOT ERROR]
The file was booted from the SD memory card to
the program memory or standard ROM but it was
not booted to the CPU module due to either of the
following reasons.
• The passwords for the password 32 do not
match between transfer source file and
destination file.
• The password 32 is not configured for the
transfer source file while it is configured for the
destination file.
■Collateral information
• Common information: File name/Drive name
• Individual information:-
■Diagnostic Timing
• At power-on/At reset
• Check the setting of the password 32 for the
transfer source file and destination files.
• Delete the boot setting from the parameter file
of the SD memory card.
LCPU
Error
Code
Error Contents and Cause Corrective Action
LED Status
CPU Status
Corresponding
CPU

Mitsubishi MELSEC Q Series Specifications

General

Brand	Mitsubishi
Model	MELSEC Q Series
Category	Controller
Language	English