To install
1. Remove any foreign material in or
around the connectors and ensure the ve-
hicle seat belt is in its normal storage po-
sition.
2. Remove the head restraint from the loca-
tion in which you wish to install a child
restraint.
Refer to “Head restraints” on page 5-05.
3. When installing a child restraint system
in the front passenger seat, adjust seat
slide to its most rearward position.
4. Push the child restraint system’s connec-
tors (A) into the lower anchorages (B) in
accordance with the instructions provi-
ded by the child restraint system’s manu-
facturer.
For easier access to the rear seat lower
anchorage, the rear seatback may be re-
cline rearward. After it is security fas-
tened, adjust the seatback to 4 steps for-
ward from most reclined position.
A- Connector
B- Lower anchorage
C- Vehicle seat cushion
D- Vehicle seatback
If your child restraint system has a sup-
port leg, make sure that there is a sup-
port leg at the stable position on the
floor.
If your child restraint system requires the use
of a tether strap, fasten the tether strap in ac-
cordance with step 5.
6.
5. Latch the tether strap hook (E) of the
child restraint system to the tether an-
chorage bar (F) and tighten the top tether
strap hook so it is securely fastened.
To Next Page
Loading...
