EasyManua.ls Logo

Mitsubishi Outlander PHEV 2019

Mitsubishi Outlander PHEV 2019
602 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CAUTION
l
Be careful not to spill beverages, etc. around
the electrical parking switch. The electrical
parking switch may be stuck to the pressed
position when it is pressed.
NOTE
l
When the selector lever is shifted from the
“P” position or to the “P” position, operating
noise and vibration of the parking lock are
felt, but this is normal.
Electrical Parking switch re-
minder buzzer
If the drivers door is opened with the select
position other than “P” when the vehicle is at
a stop, the buzzer sounds to warn to press the
electrical parking switch.
Regenerative braking level
selector (paddle type)*
E00636700148
Regenerative braking level selector can
quickly change the regenerative brake force
keeping your hand on the steering wheel
when you release your foot from the acceler-
ator pedal while driving.
By pulling the regenerative braking level se-
lector, the brake force (amount of electrical
energy to charge the drive battery) can be ad-
justed according to the driving condition such
as before a curve or a downhill.
Regenerative braking level can be switched
in the 6 level from B0 (without regenerative
brake force) to B5 (large regenerative brake
force).
increase in
regenerative force
decrease in
regenerative force
CAUTION
l
If a large regenerative brake force is applied
on a slippery road, tyres may skid. Always
drive safely in accordance with the prevail-
ing road condition.
l
If you operate the right and left paddles si-
multaneously, the regenerative brake force
level may not change.
NOTE
l
Repeated continuous operation of a paddle
will continuously change the brake force
levels.
l
If you turn on the SPORT mode, the regener-
ative braking force level will automatically
switch to B5. After the regenerative braking
force level is switched, the regenerative
braking level can be adjusted by the regener-
ative braking level selector.
l
If you turn on the cruise control when the
level B0 or B1 (smaller regenerative brake
force) is selected, the level is returned to the
normal level B2 automatically.
l
When stronger regenerative braking is gen-
erated, the stop lamps will illuminate even
when the brake pedal is not depressed.
l
Under the cruise control, the level B0 or B1
cannot be selected. The buzzer sounds if you
try to select these levels.
Regenerative braking level selector (paddle type)*
7-19
OGGE19E1
Starting and driving
7

Table of Contents

Other manuals for Mitsubishi Outlander PHEV 2019

Related product manuals