Bonnet
E01000304689
To open
1. Pull the release lever towards you to un-
lock the bonnet.
2. Raise the bonnet while pressing the safe-
ty lock.
NOTE
l
Only open the bonnet when the wipers are in
the original position. In any other position,
the wipers could damage the paint or bonnet.
3. Support the bonnet by inserting the sup-
port bar in its slot.
CAUTION
l
Note that the support bar may disengage the
bonnet if the open bonnet is lifted by a
strong wind.
l
After inserting the support bar into the slot,
make sure the bar supports the bonnet se-
curely from falling down on to your head or
body.
To close
1. Unlatch the support bar and clip it in its
holder.
2. Slowly lower the bonnet to a position
about 20 cm above the closed position,
then let it drop.
Bonnet
11-04
OGGE19E1
Maintenance
11
To Next Page
Loading...
