EasyManuals Logo

Mitsubishi Outlander PHEV 2019 User Manual

Mitsubishi Outlander PHEV 2019
602 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #275 background imageLoading...
Page #275 background image
NOTE
The selector lever is shifted to “B” when
the select position is in “R”.
To resume the set speed
E00609802161
If the set driving speed is deactivated by the
condition described in “To deactivate” on
page 7-49, you can resume the previously set
speed by pushing up the "RES +" switch (C)
while driving at a speed of approximately
40 km/h (25 mph) or higher. The “SET” indi-
cator appears on the information screen in the
meter cluster.
Under either of the following conditions,
however, using the switch does not allow you
to resume the previously set speed. In these
situations, repeat the speed setting procedure:
l
The CRUISE CONTROL ON/OFF
switch is pressed.
l
The operation mode is put in OFF.
l
The indicator display goes off.
Speed Limiter*
E00633201093
The Speed Limiter is a driver assist function
to prevent from exceeding the speed set by
driver while Plug-in Hybrid EV System pow-
er control.
CAUTION
l
Because the system does not use service
brake (hydraulic brake), the vehicle speed
may exceed the set speed on the downhill.
If a driver wants to keep the vehicle speed in
such a situation, he/she must put on a service
brake.
If the vehicle speed exceeds the set speed
(about 3 km/h (2 mph)), the indicator will
brink in the combination meter.
If the vehicle speed exceeds the set speed
about +3 km/h (2 mph) more than about 5
seconds after indicated alert message, beep
alert is sounded for about 10 seconds at the
most.
While running without alert message, if you
decrease the set speed and vehicle speed is
more than set speed about +3 km/h (2 mph),
alert message is displayed but beep alert is
delayed.
In this case, when vehicle speed keeps ex-
ceeding set speed about +3 km/h (2 mph) for
about 30 seconds after the alert message is
appeared, beep alert is sounded for about 10
seconds at the most.
If the vehicle speeds decreases less than set
speeds after the alert message is appeared,
the message is disappeared. When beep alert
is sounding, the beep alert also goes off.
NOTE
l
However, this gives priority to audio and
visual signal of safety reasons or driver’s de-
mand.
Speed Limiter*
7-50
OGGE19E1
Starting and driving
7

Table of Contents

Other manuals for Mitsubishi Outlander PHEV 2019

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mitsubishi Outlander PHEV 2019 and is the answer not in the manual?

Mitsubishi Outlander PHEV 2019 Specifications

General IconGeneral
BrandMitsubishi
ModelOutlander PHEV 2019
CategoryAutomobile
LanguageEnglish

Related product manuals