CAUTION
•
When the reversing speed of your vehicle
is approximately 18 km/h (11 mph) or
higher.
•
When the speed of an approaching vehicle
is approximately 7 km/h (5 mph) or less.
•
If the sensor detection area is blocked by
a nearby object, such as a wall or parked
vehicle.
•
When a vehicle is approaching from
straight behind your vehicle.
•
When your vehicle is exiting from an an-
gled parking spot.
•
Immediately after the RCTA has been
turned on.
•
Immediately after the operation mode of
the power switch has been put in ON.
•
When the bumper surface around the sen-
sor is covered with dirt, snow and ice, etc.
•
When the sensor becomes extremely hot
or cold, such as after the vehicle has been
parked for a prolonged time under the
blazing sun or in cold weather.
CAUTION
l
If the bumper has experienced an impact, the
sensor may have been damaged and the
RCTA may not function properly. Have the
vehicle inspected at a MITSUBISHI
MOTORS Authorized Service Point.
To operate
1. Press the BSW switch while the opera-
tion mode is put in ON.
(Refer to “Blind Spot Warning (BSW):
To operate” on page 7-84.)
2. When the select position is put in the
“R” (REVERSE) position, the RCTA
will operate.
NOTE
l
Set the RCTA to OFF when towing.
l
The Blind Spot Warning lamp in the outside
rear-view mirror may not be visible due to
strong direct sunlight or the glare from the
headlamps of vehicles behind you during
night driving.
When a problem is detected in
the system
If the system detects a problem, a warning is
displayed on the information screen in the
multi-information display.
Refer to “Blind Spot Warning (BSW): Sys-
tem problem warning” on page 7-85.
Lane Departure Warning
(LDW)*
E00635701281
By recognizing through a sensor (A) the lane
in which your vehicle is running, the LDW
gives you a warning when your vehicle is
likely to drift from its lane with an audible
alarm and a visual alarm displayed on the in-
formation screen of the multi-information
display.
Lane Departure Warning (LDW)*
7-88
OGGE19E1
Starting and driving
7