Disconnect the quick charge connector
according to the manual of the quick
charger.
CAUTION
l
As the quick charge connector is heavier in
comparison to the normal charge connector,
allowing it to drop could cause damage to
the vehicle or charge connector or personal
injury. When removing the connector, be
sure to pull it out straight and as carefully as
possible.
l
Do not leave the quick charge connector
connected to the quick charge port after
charging.
Doing so, someone might stumble and it
could cause an injury or the quick charging
connection might be damaged by playing it.
NOTE
l
Although it is possible to start the electric
motor unit if quick charging has not finished
normally, the charging indicator is continu-
ously blinking. In such a situation, perform
quick charging again and finish it normally
or contact a MITSUBISHI MOTORS Au-
thorized Service Point.
8. Close the inner lid and press the rear of
the charging lid until it clicks to close it.
WARNING
l
After charging, be sure to close the inner
lid and the quick charging lid completely.
Be careful that water or dust does not en-
ter in the quick charge port, inner lid and
quick charge connector.
Entry of water or dust could cause fire,
electric shock or short circuit.
l
After charging, be sure to disconnect the
charge connector from the charge port.
If the charge connector is only partially
engaged and the connector latch is un-
locked, you could put the operation mode
of the power switch in ON and the vehicle
could start moving. It could lead to an un-
expected accident.
NOTE
l
If the operation mode of the power switch is
put in ON with the quick charge connector
connected to the quick charge port, the plu-
gin hybrid EV system cannot be started.
Be sure to disconnect the quick charge con-
nector before start.
l
Charging may be completed before full
charge. This is a control for efficient charge
and not a malfunction.
To achieve full charge, repeat charging from
Step 5 again.
NOTE
l
Make sure that the inner lid is completely
closed.
If the charging lid is forcibly closed without
completely closing inner lid, the hinge on
the inner lid may be broken.
l
While the charging lid is open, if the doors
and tailgate are locked with the central door
lock, the keyless entry system or the keyless
operation system, the charging lid will lock
when the charging lid is closed.
l
When the operation mode is switched to ON
while the charging lid is not completely
closed, a warning may be displayed on the
information display of the multi information
display.
Refer to “Warning display list” on page
6-26.
MITSUBISHI Remote
Control*
E08304200215
The MITSUBISHI Remote Control allows to
operate the vehicle within the communication
range of the wireless LAN device (which
conforms to IEEE 802.11b and supports iOS
or Android). The following operations are
available.
MITSUBISHI Remote Control*
3-20
OGGE19E1
Charging
3
To Next Page
Loading...
Need help?
General
