Mitsubishi Outlander PHEV 2019

NOTE
l
The communication distance differs depend-
ing on the wireless LAN device, due to this
the communication may go down.
1- Wireless LAN device
2- Antenna
l
Charging timer
If you specify the charge start and/or
stop time with the normal charge cable
connected, charging is started and/or
stopped at that time.
l
Remote Climate Control
By setting the remote climate control to
operate at a predetermined time, cabin
comfort can be improved or visibility
can be ensured (defrosting/demisting)
before getting in the vehicle.
l
Customize (function setting change)
The function setting of the keyless oper-
ation system, outside rear-view mirror,
operation mode of the power switch, air
conditioning, lamps and windscreen
wipers can be changed by MITSUBISHI
Remote Control.
NOTE
l
The electric heater is required to activate the
reservation functions of heater, defroster and
demister.
l
In a vehicle equipped with the Smartphone
Link Display Audio or the MITSUBISHI
Multi-Communication System (MMCS), it
is possible to change the setting by means of
screen operations.
Refer to the separate owner’s manual for de-
tails.
l
If you want to quickly start normal charging
even when the charging timer is already set,
you can cancel the charging timer and start
the normal charging by the following meth-
ods.
[How to temporarily cancel the charging
timer]
You can temporarily cancel the charging
timer by the following methods.
In addition, the predetermined charging tim-
er settings will automatically return after the
charging timer is turned on again or the op-
eration mode of the power switch is put in
ON.
NOTE
•
Keyless operation
After connecting the normal charging ca-
ble and closing all the doors and the tail-
gate, you can cancel the charging timer by
pressing the switch (A) of the keyless op-
eration key twice within 2 seconds. When
the charging timer is cancelled, the hazard
warning lamps will blink four times.
•
Wireless LAN device
[How to cancel the charging timer]
The charging timer can be cancelled by
the following methods.
•
Wireless LAN device
•
Smartphone Link Display Audio*
•
MITSUBISHI Multi-Communication
System (MMCS)*
l
When using the charging timer, use the EV
charging cable. When using a home or pub-
lic charging device (EVSE: Electric Vehicles
Supply Equipment), the charging timer may
not be started.
MITSUBISHI Remote Control*
3-21
OGGE19E1
Charging
3