Mitsubishi Outlander PHEV 2019

4. Lightly press the multi information dis-
play switch to select the units.
5. Press and hold the multi information dis-
play switch for about 2 seconds or more
to change the setting to the selected unit.
NOTE
l
The display units for the average fuel con-
sumption and the driving range is switched,
but the units for the indicating needle
(speedometer), the odometer and the tripme-
ter will remain unchanged.
The distance units is also switched in the fol-
lowing combinations to match the selected
fuel consumption unit.
Fuel consumption Distance (driving
range)
L/100 km km
mpg (US) mile(s)
mpg (UK) mile(s)
km/L km
Changing the temperature unit
E00523101913
The display unit for temperature can be
switched.
1. Press and hold the multi information dis-
play switch for about 2 seconds or more
to switch from the setting mode screen
to the menu screen.
Refer to “Changing the function set-
tings” on page 6-17.
2. Lightly press the multi information dis-
play switch to select “
” (temperature
unit setting).
3. Press and hold the multi information dis-
play switch for about 2 seconds or more
to switch in from °C to °F, or from °F to
°C. The setting is changed to the selec-
ted temperature unit.
NOTE
l
The temperature value on air conditioner
panel is switched in conjunction with outside
temperature display unit of the multi infor-
mation display.
However, “°C” or “°F” are not shown to
temperature display of an air conditioner.
l
On vehicles equipped with the Smartphone
Link Display Audio or the MITSUBISHI
Multi- Communication System (MMCS),
the temperature value of Smartphone Link
Display Audio or MITSUBISHI Multi-Com-
munication System (MMCS) is switched in
conjunction with the outside temperature
display unit of the multi information display.
However, “°C” or “°F” is not shown to the
air conditioner screen of MITSUBISHI Mul-
ti- Communication System (MMCS).
Changing the display language
E00523201741
The language of the multi information dis-
play can be switched.
1. Press and hold the multi information dis-
play switch for about 2 seconds or more
to switch from the setting mode screen
to the menu screen.
Refer to “Changing the function set-
tings” on page 6-17.
2. Lightly press the multi information dis-
play switch to select “LANGUAGE”
(language setting).
3. Press and hold the multi information dis-
play switch for about 2 seconds or more
to display “LANGUAGE”.
4. Lightly press the multi information dis-
play switch to select the desired lan-
guage.
Multi information display
6-20
OGGE19E1
Instruments and controls
6