Screen Cause Solution (Reference)
l
There is a fault in the electronic immobil-
izer (Anti-theft starting system).
l
Put the operation mode in OFF, and then
start the Plug-in Hybrid EV System again.
If the warning is not cancelled, please
contact a MITSUBISHI MOTORS Au-
thorized Service Point.
l
The driver’s door is open when the opera-
tion mode is in any mode other than OFF.
l
Put the operation mode in OFF.
Refer to “Operation mode ON reminder
system” on page 7-13.
l
An attempt was made to lock all the doors
and the tailgate when the operation mode
is in any mode other than OFF.
l
Put the operation mode in OFF.
Refer to “Operation mode OFF reminder
system” on page 7-13.
l
There is a fault in the electrical system.
l
Immediately stop the vehicle in a safe
place.
We recommend you to contact a
MITSUBISHI MOTORS Authorized
Service Point.
l
The engine is overheated.
l
Stop the vehicle in a safe place and take
corrective measures.
Refer to “Engine overheating” on page
9-04.
l
You put the operation mode in ON with-
out fastening your seat belt.
l
Fasten your seat belt properly. Refer to
“Seat belt reminder” on page 5-11.
Indication lamp, warning lamp, and information screen display list
6-36
OGGE19E1
Instruments and controls
6
To Next Page
Loading...
