SAVE/CHARGE mode switch
E08503000029
If you press the switch with the operation
mode of the power switch in ON, you can
charge the drive battery mode in the order of
SAVE, CHARGE, OFF, SAVE.
Refer to “SAVE/CHARGE mode switch”
on page 7-28.
Battery save mode
When the READY indicator is illuminated,
operate the SAVE/CHARGE mode switch to
change the battery save mode. The engine
will start in order to preserve the remaining
power of the drive battery and the vehicle
will operate in the series hybrid mode or the
parallel hybrid mode depending on the re-
maining power in the drive battery.
Refer to “Battery save mode” on page
7-29.
Battery charge mode
When the READY indicator is illuminated,
operate the SAVE/CHARGE mode switch to
change the battery save mode. The engine
will start to charge the drive battery to nearly
full.
Refer to “Battery charge mode” on page
7-29.
S-AWC (Super-All Wheel Con-
trol)
E08501900170
S-AWC is an integrated vehicle dynamics
control system that helps enhance driving
performance, cornering performance, and ve-
hicle stability over a wide range of driving
conditions through integrated management of
the twin motor 4WD, the AYC (Active Yaw
Control), the ABS and the ASC.
Refer to “S-AWC (Super-All Wheel Con-
trol)” on page 7-20.
S-AWC drive mode
E08503200021
Select the drive mode from the following
three types to suit the driving conditions.
Drive mode Function
NORMAL
This mode can be
used on both dry and
wet roads. The distri-
bution of driving/
braking torque to
each wheel is auto-
matically controlled
according to the driv-
ing condition.
SNOW
This mode is for
driving on slippery
road surfaces, such
as snow-covered
roads and improves
stability on a slippery
road.
Quick guide
1-21
OGGE19E1
Overview
1
To Next Page
Loading...
