CAUTION
l
Use tyres of the same specified size, same
type, same brand and with no wear differ-
ence. If tyres of a different size, type, brand
or degree of wear are used, a warning of EV
system abnormality may be displayed.
NOTE
l
Even if the S-AWC drive mode is selected,
after turning the operation mode of the pow-
er switch OFF and turning to ON again, the
S-AWC drive mode is set to “NORMAL”.
l
The drive mode can be switched while driv-
ing or stopped.
S-AWC drive mode display
E00653300022
Example: “SNOW” mode is selected.
The currently selected drive mode is dis-
played on the multi-information display.
In addition, when the drive mode is changed,
the selected mode appears on the interrupt
display screen of the information screen in
the multi-information display.
The drive mode display will appear on the in-
formation screen for a few seconds, and then
the original screen will return.
S-AWC operation display
E00623101347
The S-AWC operation status can be dis-
played on the information screen in the multi-
information display.
To display the status, press the multi-infor-
mation display switch to change the informa-
tion screen.
Refer to “Information screen (when the oper-
ation mode is ON)” on page 6-09.
Display example
The S-AWC operation status is displayed.
Yaw control function display
The amount of the yaw moment is displayed
as a bar graph.
A,D- Clockwise yaw moment about the
vehicle’s center of gravity
B,C- Anticlockwise yaw moment about
the vehicle’s center of gravity
Torque distribution function display
The torque distribution between the front and
rear wheels is displayed in section E of the
meter as a bar graph.
If the red line is on the front, the torque of the
front motor will be high. If it is behind it, the
torque of the rear motor will be high.
S-AWC (Super All Wheel Control)
7-22
OGGE19E1
Starting and driving
7
To Next Page
Loading...
