Mitsubishi Outlander PHEV 2019

2. Accelerate or decelerate to your desired
speed, then push down and release the
"SET -" switch (B). The vehicle will
then maintain the desired speed.
The “SET” indicator appears on the in-
formation screen in the meter cluster.
NOTE
l
When you release the "SET -" switch (B),
the vehicle speed will be set.
To increase the set speed
E00609402008
There are 2 ways to increase the set speed.
"RES +" switch
Push up and hold the "RES +" switch (C)
while driving at the set speed, and your speed
will then gradually increase.
When you reach your desired speed, release
the switch. Your new cruising speed is now
set.
To increase your speed in small amounts,
push up the "RES +" switch (C) for less than
approximately 1 second and release it.
Each time you press the "RES +" switch (C),
your vehicle will go approximately 1.6 km/h
(1 mph) faster.
Accelerator pedal
While driving at the set speed, use the accel-
erator pedal to reach your desired speed and
then push down the "SET -" switch (B) and
release the switch momentarily to set a new
desired cruising speed.
To decrease the set speed
E00609501930
There are 2 ways to decrease the set speed.
"SET -" switch
Push down and hold the "SET -" switch (B)
while driving at the set speed, and your speed
will slow down gradually.
Cruise control*
7-47
OGGE19E1
Starting and driving
7