EasyManua.ls Logo

Mitsubishi Outlander PHEV 2019

Mitsubishi Outlander PHEV 2019
602 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
When the ACC is initialized, a buzzer sound
is heard and the “SET” indicator lights up on
the screen. At the same time, the display
showing the following distance setting and
the running-ahead vehicle symbol (only when
the ACC is detecting a vehicle in front) is
switched to the in-control mode display.
NOTE
l
The ACC cannot start the control when any
of the following conditions is present. You
are alerted to this state by a sounding buzzer.
When the vehicle speed is lower than ap-
proximately 10 km/h (6 mph) or 180 km/h
(112 mph) or higher.
When the vehicle is running at a speed be-
tween approximately 10 km/h (6 mph)
and 40 km/h (25 mph) and the ACC does
not detect a vehicle in front.
When ASC is in the OFF state.
When ABS, ASC or TCL is working.
NOTE
When the select position is in the “P”
(PARK), the “R” (REVERSE) or the “N”
(NEUTRAL) position.
While the brake pedal is being depressed.
When the parking brake is applied.
When the system determines that its per-
formance has been degraded due to con-
taminants adhered to the sensor.
When there is any abnormality in the sys-
tem.
To increase the set speed
There are two ways to increase the set speed.
By using the “RES +” switch:
The set speed increases by 1 km/h (1 mph)
every time you push up the “RES +” switch
while the ACC control is working. If you
hold the switch pushed up, the set speed in-
creases in 5 km/h (3 mph) increments.
CAUTION
l
The setting speed should be set up the suita-
ble speed according to a situation.
NOTE
l
There is some time lag between the setting
to a new speed and actually accelerating to
that speed.
l
Speed setting operation is possible even in
presence of a vehicle in front. In this case,
however, the set speed alone increases with-
out actual acceleration taking place.
l
When the switch is held pushed, a buzzer
sounds every time the set speed changes.
By using the accelerator pedal:
When the accelerator pedal is depressed
while driving with the ACC control working,
you can accelerate the vehicle temporarily
beyond the presently set speed.
Adaptive Cruise Control System (ACC)*
7-62
OGGE19E1
Starting and driving
7

Table of Contents

Other manuals for Mitsubishi Outlander PHEV 2019

Related product manuals