To Next Page

To Previous Page

Situation Operation display Buzzer

When an obstacle is detected behind your vehicle with the se-

lector lever in the “R” position, if the accelerator pedal is de-

pressed promptly and too strongly, the motor output is sup-

pressed for up to approximately 5 seconds.

WARNING

Do not overly rely on the UMS. It is never a substitute for your safe and careful driving. Always be careful to operate the accelerator pedal perceiv-

ing the environmental conditions. Misoperation can lead to a serious accident.

As the UMS is not a function to keep the stop condition of the vehicle, depress the brake pedal according to the environmental condition.

Depending on the situation, the system does not operate even if the vehicle or the obstacle in front and behind your vehicle and this may cause the

vehicle to start suddenly and lead to a serious accident.

If the vehicle is trapped in the railway crossing because the system is activated as the crossing barrier is misrecognised as an obstacle, escape from

the railway crossing without any panic by one of the following methods.

•

Release the foot from the accelerator pedal and lightly depress the pedal again.

•

Turn the system OFF. (Continuously press the FCM and UMS ON/OFF switch for more than 3 seconds.)

•

Continuously depress the accelerator pedal for more than 5 seconds.

•

Repeat to press the accelerator pedal quickly to its full stroke more than three times.

Do not perform inspection of the system operation on your own. Depending on the situation, this may cause the system to not operate properly and

lead to a serious accident.

Ultrasonic misacceleration Mitigation System (UMS)*