Back sensor (vehicles without a towing
bar)
Vehicle to obstacle
distance
Warning display/
sound cycle
Approx. 125 to
80 cm
Intermittent
Approx. 80 to 40 cm Fast intermittent
Within approx.
40 cm
Continuous
Back sensor (vehicles with a towing bar)
Vehicle to obstacle
distance
Warning display/
sound cycle
Approx. 125 to
100 cm
Intermittent
Approx. 100 to
60 cm
Fast intermittent
Within approx.
60 cm
Continuous
CAUTION
l
The distances given are to be used for refer-
ence only, as errors may be caused by vari-
ous factors, such as temperature, humidity,
or the shape of the obstacles.
NOTE
l
When the sensors are detecting different ob-
stacles at the same time, the information
screen in the multi information display indi-
cates the directions of the obstacles each
sensors are detecting. However, closer obsta-
cles are given priority over other detected
obstacles and the warning buzzer sounds to
inform you of closer obstacles.
Changing the detection areas
E00615801257
The detection areas can be changed as fol-
lows:
Vehicles with a towing bar
While the operation of the system is stopped
at the “SONAR” switch, push the “SONAR”
switch approximately 3 seconds or more, and
release it. The buzzer sounds twice to indi-
cate that the detection area has been changed.
Vehicles without a towing bar
While the operation of the system is stopped
at the “SONAR” switch, push the “SONAR”
switch approximately 3 seconds or more, and
release it. The buzzer sounds once to indicate
that the detection area has been changed.
NOTE
l
The detection area will not change if you
keep the “SONAR” switch pushed for 10
seconds or more.
l
After pushing the “SONAR” switch, revers-
ing sensor system operation differs accord-
ing to the detection area setting.
•
Setting when towing bar is not equipped
When the selector lever is moved to the
“R” position, the reversing sensor system
will operate even if the corner sensor op-
eration was stopped by pushing the “SO-
NAR” switch.
•
Setting when towing bar is equipped
When the reversing sensor system opera-
tion was stopped by pushing the “SO-
NAR” switch, the reversing sensor system
will not operate until the Plug-in Hybrid
EV System has been stopped even if the
selector lever is moved to the “R” posi-
tion.
To resume the reversing sensor system
operation, push the “SONAR” switch or
stop and restart the Plug-in Hybrid EV
System, and then move the selector lever
to the “R” position.
Reversing sensor system*
7-100
OGGE19E1
Starting and driving
7
To Next Page
Loading...
Need help?
General
