l
Disable automatic air selection control
Even when the AUTO switch is pressed,
the air selection switch is not controlled
automatically.
l
Setting change method
Hold down the air selection switch for
approximately 10 seconds or more.
• When the setting is changed from ena-
ble to disable
3 sounds are emitted and the indica-
tion lamp flashes 3 times.
• When the setting is changed from dis-
able to enable
2 sounds are emitted and the indica-
tion lamp flashes 3 times.
On vehicles equipped with the Smart-
phone Link Display Audio or the
MITSUBISHI Multi-Communication
System (MMCS), screen operations can
also be used to change the setting. Refer
to the separate owner’s manual for de-
tails.
NOTE
l
The factory setting is “Enable automatic air
selection control”.
l
When the demister switch is pressed, in or-
der to prevent misting of the windows the
ventilator automatically switches to outside
air even if “Disable automatic air selection
control” is set.
AUTO switch
E00702601047
When the AUTO switch is pressed, the indi-
cation lamp (A) comes on and the mode se-
lection, blower speed adjustment, recircula-
ted/outside air selection, temperature adjust-
ment, and air conditioner ON/OFF status are
all controlled automatically.
Air conditioning switch
E00703502675
Push the switch to turn the air conditioner on,
the “
” indicator (A) will be shown in the
display.
Push the switch again to switch it off.
NOTE
l
If a problem is detected in the air condition-
ing system, the “ ” indicator blinks. Press
the air conditioning switch once to turn it
off, then once more to turn it back on. If the
“ ” indicator does not blink for a while,
there is nothing wrong. If it starts to blink
again, we recommend you to have it
checked.
Customizing the air conditioning switch
E00739700137
Functions can be changed as desired, as sta-
ted below.
Automatic climate control air conditioner
8-11
OGGE19E1
For pleasant driving
8
To Next Page
Loading...
