－13－
(7) Press key on the operation panel.
Then presser foot goes down automatically,
and wind mode window will be appeared.
(8) Step on the black color foot switch (NO.5)
again to make work holder down.
(9) Step on the gray color start foot switch
(NO.6). The thread is kept winding to the
bobbin (NO.2) while the gray color start
switch is stepping on.
(10) When the bobbin becomes full of
the thread, the adjust lever (NO.4) is
returned to the original position.
(11) Stop to step the gray foot switch
and press
the key to exit winding mode, and
press the key, to back to the
standard operation windows will be
appeared.
(12) To wind the bobbin thread during
the sewing operation, carry out above (3)
and (4) procedure then, the bobbin winding
is performed automatically.
(13) Regarding the adjustment for the bobbin thread winding volume, please refer to
the instructions in the paragraph [7-8 Adjustment of the bobbin winder] in the following
page.
b
a
3
2
1
4
6
5
To Next Page
Loading...
