－26－
7-7. Adjustment of the wiper
(1) Loosen the wiper setscrew (No.3) and adjust the wiper (No.1) to be positioned where the
wiper (No.1) passes under the needle point (No.2) with about 2mm clearances right after
the sewing machine is stopped running at the needle upper position (the thread take up
lever's highest position).
NOTE When the presser foot position or the presser foot lift is changed, the wiper (No.1) may
collide with the presser foot (No.4). In that case, please do not use the wiper (No.1).
(2) If do not use the wiper (No.1), cancel
the wiper function with the operation
panel as follows.
a) Press the key at the normal
mode condition, then MENU MODE is
appeared.
b) Press the key. Then below
screen will be appeared.
c) Press the key.
d) And then press the [WIP] key and
select the [OFF] key.
2
1
4
3
2mm
1
To Next Page
Loading...
