2 - 6 2 - 6
MELSEC-Q
2 INPUT MODULE SPECIFICATIONS
2.6 QX40-TS DC Input Module (Positive Common Type)
This module is a spring clamp terminal block type and an input module that has
indicators for checking the insertion state of wire.
Type
Specifications
DC input module (Positive common type)
QX40-TS Appearance
Number of input points 16 points
Isolation method Photocoupler
Rated input voltage 24VDC (+20/-15%, ripple ratio within 5%)
Rated input current Approx. 4mA
Input derating No
ON voltage/ON current 19V or higher/3mA or higher
OFF voltage/OFF current 11V or lower/1.7mA or lower
Input impedance Approx. 5.6kΩ
Response
time
OFF to ON
1ms/5ms/10ms/20ms/70ms or less (configured in PLC parameter)
1
(Default: 10ms)
ON to OFF
1ms/5ms/10ms/20ms/70ms or less (configured in PLC parameter)
1
(Default: 10ms)
Dielectric withstand voltage 560VAC rms/3 cycles (altitude 2000m)
Insulation resistance 10MΩ or more by insulation resistance tester
Noise immunity
By noise simulator of 500Vp-p noise voltage, 1 s noise width
and 25 to 60Hz noise frequency
First transient noise IEC61000-4-4: 1kV
Protection degree IP2X
Common terminal arrangement 16 points/common (common terminal: TB17)
Number of occupied I/O points 16 points (I/O assignment is set as a 16-point input module.)
Operation indicator ON indication (LED)
External connections Two-piece spring clamp terminal block
Applicable wire size
0.3 to 2.0mm
2
core (22 to 15 AWG)
Applicable crimping terminal Refer to section 9.1
Internal current consumption
(5VDC)
50mA (TYP. all points ON)
Weight 0.16kg
External connection Terminal block No. Signal name
TB1 X00
TB2 X01
TB3 X02
TB4 X03
TB5 X04
TB6 X05
TB7 X06
TB8 X07
TB9 X08
TB10 X09
TB11 X0A
TB12 X0B
TB13 X0C
TB14 X0D
TB15 X0E
TB16 X0F
TB17 COM
TB18 Vacant
1: For the setting method, refer to Section 1.3.1.
1
2
3
4
5
6
7
8
9
10
12
13
14
15
16
18
17
0
8
1
9
2
A
3
B
4
C
5
D
6
E
7
F
QX40-TS
11
To Next Page
Loading...
