Mitsubishi QX10 - QY80-TS Transistor Output Module (Source Type)

3 - 16 3 - 16
MELSEC-Q
3 OUTPUT MODULE SPECIFICATIONS
3.15 QY80-TS Transistor Output Module (Source Type)
This module is a spring clamp terminal block type and an output module that has
indicators for checking the insertion state of wire.
Type
Specifications
Transistor output module (Source Type)
QY80-TS Appearance
Number of output points 16 points
Isolation method Photocoupler
Rated load voltage 12-24VDC (+20/-15%)
Maximum load current 0.5A/point, 4A/common
Maximum inrush current 4A, 10ms or less
Leakage current at OFF 0.1mA or less
Maximum voltage drop at ON 0.2VDC (TYP.) 0.5A, 0.3VDC (MAX.) 0.5A
Response time
OFF to ON 1ms or less
ON to OFF 1ms or less (rated load, resistive load)
Surge suppressor Zener diode
Fuse 6.7A (unchangeable) (fuse capacity: 50A)
Fuse blown indicator
Provided (When a fuse blows, LED turns on and a signal is output to the
CPU module.) 1
External supply
power
Voltage 12-24VDC (+20/-15%) (ripple ratio within 5%)
Current 20mA (at 24VDC)
Dielectric withstand voltage 560VAC rms/3 cycles (altitude 2000m)
Insulation resistance 10MΩ or more by insulation resistance tester
Noise immunity
By noise simulator of 500Vp-p noise voltage, 1 s noise width
and 25 to 60Hz noise frequency
First transient noise IEC61000-4-4: 1kV
Protection degree IP2X
Common terminal arrangement 16 points/common (common terminal: TB17)
Number of occupied I/O points 16 points (I/O assignment is set as a 16-point output module.)
Operation indicator ON indication (LED)
External connections Two-piece spring clamp terminal block
Applicable wire size
0.3 to 2.0mm
2
core (22 to 15 AWG)
Applicable crimping terminal Refer to section 9.1
Internal current consumption
(5VDC)
80mA (TYP. all points ON)
Weight 0.17kg
1: Fuse blown is not detected when the external power supply is shut off.
1
2
3
4
5
6
7
8
9
10
12
13
14
15
16
18
17
0
8
1
9
2
A
3
B
4
C
5
D
6
E
7
F
QY80-TS
FUSE
11