Mitsubishi XL1XU Service Manual

- 2 -
¢¢
Adjustment with Microsoft
®
Windows
®
95/98/Me/XP Operating System
1. Starting
1. Start Windows
®
95/98/Me/XP.
2. Double click on the [Accessories] folder.
3. Double click on the [Hyper Terminal] folder.
4. Double click on the [HyperTrm] icon.
2. Hyper Terminal Setting
1. Click on [Properties] in the File menu on the
Hyper Terminal window.
The [Connection Properties] window will open.
Make settings on this window referring to the
table on the right.
2. Click on [Call] in the Communication menu on
the Hyper Terminal window to make the projector
accessible.
3. Adjustment
Type the adjustment command and the adjustment value of the Hyper Terminal window in capital alphanumeric letters, and
press the ENTER key.
4. Writing Adjustment Value
Type the adjustment command and the adjustment value on the Hyper Terminal window in capital alphanumeric letters, and
press the ENTER key.
Note: This step is not necessary for “ADC offset/gain adjustment,” which is carried out automatically.
5. Closing
Click on the Close button in the upper-right corner of the window to exit the Hyper Terminal.
Close all the opening windows before exiting Windows
®
95/98/Me/XP.
Item Setting
Connection Port (COM1-COM4)
Port settings : Bits per second 9600
: Data bits 8 bit
: Parity None
: Stop bits 1
: Flow control None
Settings : Emulation VT100
ASCII setup : ASCII Sending Send line ends with line feeds
Echo typed characters locally
Line delay : 1000 milliseconds
Character delay : 10 milliseconds
: ASCII Receiving
Append line feeds to incoming line ends

Mitsubishi XL1XU Specifications

General

Brand	Mitsubishi
Model	XL1XU
Category	Projector
Language	English