MK Welding Multi-GMAW 200 LCD PFC - Page 30

EN
CONTENT
§1 Safety ..................................................................................................... 1
§1.1 Symbols Explanation ................................................................................................... 1
§1.2 Machine Operating warnings! .................................................................................... 1
§1.3 EMC device classification ........................................................................................... 8
§1.4 EMC measure............................................................................................................... 8
§2 Overview ............................................................................................... 9
§2.1 Brief Introduction ........................................................................................................ 9
§2.2 Technical Data ............................................................................................................ 10
§2.3 Duty cycle and Over-heat ........................................................................................... 11
§2.4 Working Principle ....................................................................................................... 11
§2.5 Volt-Ampere Characteristic ...................................................................................... 12
§3 Panel Functions & Descriptions ....................................................... 12
§3.1 Machine Layout Description .................................................................................... 12
§3.2 Control Panel of welding machine ........................................................................... 14
§4 Installation & Operation ................................................................... 16
§4.1 Installation & Operation for MIG Welding ............................................................ 16
§4.1.1 Set up installation for MIG/MAG Welding .......................................................... 16
§4.1.2 Operation of MIG/MAG Synergic welding method ............................................ 18
§4.1.3 Operation of the MIG/MAG Manual welding method ....................................... 20
§4.1.4 Wire Feed Roller Selection ..................................................................................... 21
§4.1.5 Wire Installation and Set Up Guide ...................................................................... 22
§4.1.6 MIG Torch Liner Installation ................................................................................ 24
§4.1.7 MIG Torch Liner Types and Information ............................................................ 25
§4.1.8 Torch & Wire Feed Set Up for Aluminium Wire ................................................. 27
§4.1.9 Set up installation for Spool Gun .......................................................................... 29
§4.1.10 MIG Torch /Spool Gun control ............................................................................ 31
§4.1.11 MIG Welding ......................................................................................................... 34
§4.2 Installation & Operation for Stick Welding ............................................................ 42