Connecting the unit
37Installation instructions
6.5.1 Connecting the tap water connection line
Image: Water connection
a Soft water d Tap water connection
b Backflow preventer e Tap water connection line
c Soft water connection f Tap water
Requirement Water pressure complies with the specified range (see "Equipment
and connection data")
Backflow preventer installed
The connection lines are pressure-tight and suitable for tap water
1. Connect the connection lines to the tap water valves using seals.
2. Flush the connection lines thoroughly.
3. Insert dirt filters into the water connections on the unit.
4. Connect the tap water connection line to the unit.
5. Connect the soft water connection line to the unit.
6. Open the tap water valves and check the threaded connectors for
leaks.
7. Fill out the Commissioning report.
10013865-0AIBE-B
To Next Page
Loading...