Mini-Convectron Module Instruction Manual - 275513 23
Chapter 3 Operation
3.1 Preparing to Operate the Module
This chapter explains how to operate the Mini-Convectron module with a non-linear analog output
and one setpoint relay or two setpoint relays. If the module has two setpoint relays, it may also have
an optional pressure value display.
• Figure 3-1 illustrates the module with two setpoint relays and the optional display. Table 3-1 lists
features of the front panel if the module has the optional display.
• Figure 3-2 illustrates the module with one setpoint relay and no display. Table 3-2 lists features
of the front panel if the module has one setpoint relay and no display.
• Figure 3-3 illustrates the module with two setpoint relays and no display. Table 3-3 lists features
of the front panel if the module has two setpoint relays and no display.
Explosive Environment
Using the module to measure the pressure of flammable or
explosive gases can cause a fire or explosion resulting in
severe property damage or personal injury.
Do not use the module to measure the pressure of flammable
or explosive gases.
To Next Page
Loading...
Need help?
General
