CheckPoint 3 EN User Guide 17
P/N 340486-B
09/2017
Login and access levels
(Premium models only)
Login levels
Different levels of login can be set up:
NOTE! If you forget your User ID, you should create a new (ask a Supervisor).
See "Users" on page 59 for details about user and login settings.
Access levels
When device is switched on (after power off) it is locked in User access level. User access only
gives access to a limited number of functions and does not allow for parameter set-up.
To obtain full access you have to change the device to Supervisor access level.
To do so select Access level from the main Menu - see "Access level" on page 65 for details.
No login
(default setting)
At start-up the device initializes and when finished it changes
to show the measuring screen, ready for measuring. Current
user is the default User.
User login required At start-up the device initializes and when finished, you are
taken to the User screen, from where you must select a user to
go to the measuring screen, ready for measuring.
User login with ID At start-up the device initializes and when finished, you are
prompted to enter a valid User ID.
When done you are taken to the measuring screen, ready for
measuring.
To Next Page
Loading...
