Mocon CheckPoint 3 - Network Connection

DANSENSOR
28 User Guide EN CheckPoint 3
P/N 340486-B
09/2017
Network connection
NOTE! Always consult your network administrator before making network
settings, as incorrect settings can result in reduced or no network activity.
The Network setup function on the device offers 2 ways to establish the network connection
between CheckPoint 3 and the computer/tablet:
 Connect to Network
 Create Network
Connect to Network
Requirements:
 An active “Access point” (Wi-Fi router) within the reach of CheckPoint 3.
 A computer or tablet connected to the active “Access Point” (via LAN or WLAN).
On CheckPoint 3:
1. Login as Supervisor.
2. Go to Menu -> Setup -> Network.
3. Make sure Wi-Fi module is off.
4. Select Connect to Network.