CheckPoint 3 EN User Guide 23
P/N 340486-B
09/2017
Get started
When you start the device for the first time and before you start making measurements, it is
recommended that you perform some basic device settings.
Select language
Go to Menu -> Language to select the language in which you want to view the
different menus and messages - see "Language" on page 69 for details.
Set up gas concentration alarms
-Basic models:
Go to Menu -> Alarm to set values for when the measured gas concentrations
should appear on the measurement screen as not acceptable - see "Alarm" on page 46 for
details.
- Premium models:
Gas concentration alarms are set individually for each product - see "Products" on page 47
for details.
NOTE! You may experience shorter measurement times if appropriate gas alarms
have been set up.
Set up Products and Users
(Premium models only)
From the factory a default user and a default product have been created, but we highly
recommend that you create specific products and users, so that you can separate the
different measurements later on for use in product statistics etc. - see "Products" on page 47
and "Users" on page 59 for details.
Perform Setup
Go through the parameters available in the Setup menu and make appropriate settings
- see "Setup" on page 56 for details.
To Next Page
Loading...
