62 User Guide EN CheckPoint 3
P/N 340486-B
09/2017
Power save
Selecting Power save from the Setup menu will display a screen showing the various
setup parameters for the device’s power save function.
To “wake up” the device when in power save mode, simply touch the screen or press the
button.
Restore defaults Resets the settings of the 3 power save parameters below to the
factory settings.
O2 sensor power time Set the time for which the O
2
sensor remains heated and ready
after the device has been switched on or after a measurement
has been performed (0 - 999 s.).
Dim display after Set the time of device inactivity after which the display switches
into power save mode by reducing the display’s back light
intensity (10 - 999 s.).
Dim display time Set the time of device inactivity in power save mode as
described above until device automatically switches off
(10 - 999 s.).
NOTE! If device’s Wi-Fi module is switched on and
there is network activity, this will prevent the device
from switching off, even though the set time runs out.
NOTE! If device is connected to a PC via the USB cable,
it does not automatically switch off, but display turns
off.
If the cable connection is interrupted while the device
display is off, the unit will switch off immediately.
To Next Page
Loading...
