CheckPoint 3 EN User Guide 19
P/N 340486-B
09/2017
Wi-Fi status * Shows Wi-Fi connection type and/or Wi-Fi signal
strength:
..... Wi-Fi set to “Connect to Network”.
Icon indicates signal strength.
Wi-Fi set to “Connect to Network”, but Wi-Fi
module is off.
Wi-Fi set to “Create Network”
Wi-Fi set to “Create Network”, but Wi-Fi
module is off.
When Wi-Fi fast access is enabled in Network setup, the
icon also acts as a button giving fast access to the Wi-Fi
on/off setting. In this case the operator can turn the Wi-Fi
module on/off without being logged in as Supervisor.
See "Network" on page 58 for details.
Measurement validity * The icon shows the validity of the most recent
measurement.
Tapping this icon within 30 s. after performing a
measurement, will mark this measurement as invalid in
the data log, and the icon will change from to .
The icon is only visible when Invalid meas. fast access is
enabled in Data log setup, otherwise the function is only
available from the Data log menu - see "Data log" on
page 51 for details.
To Next Page
Loading...
