EasyManua.ls Logo

Model Tech Dragon Lady - Section 5: Replacement Parts; Section 6: a Note about Covering

Model Tech Dragon Lady
44 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7
Need help or have any questions? Call us at 1-714-963-0329 or send us an Email at service@globalhobby.net
Global stocks a complete line of replacement parts for your Modeltech Dragon Lady 60 ARF. Listed below are the
replacement parts that are available along with their respective part numbers for easy ordering convenience. We suggest
ordering directly from your local dealer. If your dealer does not stock Modeltech products, you can order directly from us at
the address shown below:
SECTION 5: REPLACEMENT PARTS
The covering material used on the Dragon Lady 60 ARF is real iron-on, heat-shrink covering material, not cheap "shelf
paper." Because of this, it is possible with heat and humidity changes that the covering on your airplane may wrinkle
or sag. This trait is inherent in all types of heat-shrink material. To remove any wrinkles that might be visible you will
need to purchase, or borrow from a fellow modeler, a heat iron. If you need to purchase one, the Global Heat Sealing
Iron # 360900 is recommended.
Follow this simple procedure to remove the wrinkles:
Plug in and turn on the sealing iron to the medium-high temperature setting. Allow the iron to heat up for approximately
5 - 7 minutes.
After the iron has reached temperature, lightly apply the iron to the wrinkled section of the covering. Move the iron
slowly over the wrinkled section until the covering tightens and the wrinkles disappear. You will notice that the color of the
covering will darken when it is heated. When the covering cools back down, it will return to its normal color.
If the color layer smears from any of the seams the temperature of the iron is too hot. Turn the temperature dial down
and wait about 5 minutes for the iron to adjust to the lower temperature. You can remove any excess color streaks using
a paper towel soaked with a small quantity of Acetone.
WARNING
We do not suggest storing your airplane in an extremely hot environment (like the back of your car in direct
sunlight) for any length of time. The extreme heat could cause the covering material to wrinkle or sag and
possibly damage the clear windscreen, and the fragile components of the radio system.
SECTION 6: A NOTE ABOUT COVERING
Modeltech Dragon Lady 60 - Complete - 123761
Instruction Manual - 120080
Wing Set - 120081
Fuselage Set - 120082
Stabilizer Set - 120083
Prepainted Fiberglass Cowling - 120084
Clear Windscreen - 120085
Blow-Molded Wheel Pants - 120086
Engine Mount w/Hardware - 120087
Hardware Bag - 120088
360cc Fuel Tank Assembly - 120074
Aluminum Landing Gear Strut - 120089
Tail Wheel Assembly - 120076
Decal Sheet - 120090
Global Services
18480 Bandilier Circle
Fountain Valley CA 92708
Phone: (714) 963-0329 Fax: (714) 964-6236
On the Web
http://globalservices.globalhobby.com

Related product manuals