128 • Section 5 — Equipment Cayman 2006
Guidelines to ensure long life of slide-out system:
• Inspect the roof of the slide-out for debris such as pine needles, dirt, leaves, sticks, etc. Any debris left on
the top may cause damage to the seals during retraction. If debris is present, wash with soap and water,
then rinse.
• When the room is out, visually inspect the wipe seal for dirt or other foreign material and for tears.
• In the event the slide-out room leaks, fully retract the room. If necessary, tape the exterior opening closed
with duct tape until repairs to the motorhome can be completed.
• Open a window or vent to equalize pressure during slide-out operation.
NOTE:
Slide-out adjustment is not warrantable after 12 months. DO NOT use any petroleum-based
products on the slide-out seal. Petroleum based products can damage the paint and will
cause premature aging of the rubber seal.
WARNING:
Move the driver’s seat forward before activating the slide-out room. Damage to the upholstery
can occur. The outside area must be clear of any obstructions restricting slide-out room
operation. Ensure there is five or more feet of clear space outside the slide-out room prior
to extending or damage can occur. When retracting the slide-out room, ensure there is
sufficient clearance inside the motorhome. Never move the motorhome with any slide-out
room extended.
CAUTION:
Continuous operation of the slide-out room can drain the batteries and damage the motor
from overheating.
Extending & Retracting Slide-out Rooms
To Extend Slide-out Rooms:
• Move the driver seat forward.
• Confi rm that there is at least fi ve feet of
clearance outside the motorhome for the
slide-out room to extend.
• Ensure the ignition key is in the OFF
position.
• The park brake must be applied.
• The house batteries are fully charged.
• Be sure all people, pets and objects are
clear of slide-out room path.
• Remove the lock bar.
• The slide-out room control switch is on
the system monitor panel.
• Press and hold the front slide-out room
switch in the OUT position. The slide-
out room will slowly move to the OUT
position. Release the switch to stop
room movement. To continue the room
movement, push and hold the switch in.
030802c
To Next Page
Loading...
