EnDaL smart PRODUCT CERTIFICATION
- 1 -
P R OD U CT C ERTI F ICATION
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
Modifications not expressly approved by this company could void the user's
authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.
This device complies with Industry Canada’s RSS-310. Operation is subject to the
condition that this device must not cause harmful interference and must accept any
interference, including interference that may cause undesired operation of the
device.
Cet appareil est conforme à la norme RSS-310 d'Industrie Canada. L'opération est
soumise à la condition que ce dispositif ne doit pas causer d'interférence nuisible et
doit accepter toute interférence, y compris les interférences qui peuvent entraîner
un mauvais fonctionnement de l'appareil.
This EXPERTISE is issued in accordance with the Directive 1999/5/EC of the
European Parliament and Council on radio equipment and telecommunications
terminal equipment and mutual recognition of their conformity dated 9
th
March
1999 and is only valid in conjunction with following annex: -1- (2 pages)
This device has been designed to operate with the antennas listed below (see Technical Parameter). Antennas not
included in this list are strictly prohibited for use with this device. The required antenna impedance is 50
ohms.To reduce potential radio interference to other users, the antenna type and its gain should be so chosen
that the equivalent isotropically radiated power (e.i.r.p.) is not more than that permitted for successful
communication.
Cet appareil a été conçu pour fonctionner avec les antennes énumérées ci-dessous (voir 2. Paramètres techniques). Les
antennes n’étant pas énumérées dans cette liste sont strictement interdites pour une utilisation en combinaison
avec cet appareil. L'impédance de l’antenne requise est de 50 ohms. Afin de réduire les interférences radio
potentielles pour les autres utilisateurs, le type d'antenne doit être choisi afin que la puissance isotrope
équivalente (e.i.r.p.) ne soit pas supérieure à celle permise pour réaliser une communication stable.
To Next Page
Loading...