EasyManua.ls Logo

MONI LOG EnDal smart - 1.3 Environmental and Safety Instructions

MONI LOG EnDal smart
49 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EnDaL smart INTRODUCTION
- 7 -
1.3 E N V I R O N M E N T A L A ND S A F E T Y INS T R U C T I O N S
Environment & disposal
The EnDaL smart contains, excluding the internal batteries, no corrosive or
environmentally damaging substances.
Used batteries must be immediately removed from the device and be disposed of in an
environmentally friendly manner, according to the applicable legislation. Lithium batteries are
hazardous waste.
Battery operation
The power supply is ensured in the EnDaL smart by means of 2 exchangeable
alkaline or lithium batteries (type C|R14). These can be bought in specialized stores according to
the specification stated in the instruction manual.
When lithium batteries are used on transport, the EnDaL smart must be labelled as
hazardous material of class 9, according to the Worldwide UN classification. The transport
conditions resulting due to this must be taken into account!
Please take into account that when using alternative battery types the functionality of the device
cannot be guaranteed in the entire specified temperature range from -40 to 85 °C.
ATTENTION!
Use only intrinsically safe batteries.
In case of non-compliance with the national regulations/laws applicable in the handling of
lithium batteries, any liability and warranty claim becomes void!
Decommissioning
In case of decommissioning the devices must be properly switched off and all batteries must be
removed from the cases and be disposed of in an environmentally friendly manner.