Morbark BEEVER M18R - Page 27

F C
,
,
®
Adjust angle
of wood chip
projection
The Chipping Cycle • Preparation
Figure 2.3
Wheel chocks
Chipper should sit on
a level surface with the
machine parallel to the ground
Note: Some machines have a
height adjustor. See the
Features and Function section
to adjust the height of the
discharge chute using the
height adjustor
Infeed spout is
clear of debris
Electric brake
actuator cable
Electrical
connection
Ball or pintle
hitch connection
Chain
connection
Break-away
switch
2.5
76347-282 • 12- 08