Morbark BOXER 320 - Page 28

Pre Start Inspection and Operation
3.3
NOTE: Extremely dusty or dirty working conditions may require more frequent checking,
lling and/or changing of engine oil.
• After filling the oil, wait a few minutes and check the oil level again.
Make sure to securely reinstall the dipstick into the dipstick tube before starting the engine.
Check engine fuel and ll as needed - be sure engine is OFF.
3. The Boxer has one saddle fuel tank (Item 1, Figure 3–3). Remote lter cap (Item 2, Figure
3–3) and insert a clean tank level gauge into tank and remove. This will show you the level
of gas remaining in the tank. Make sure that the tank has been lled on a daily basis.
Figure 3-3 Fuel Level Check
• Carefully pour the fuel into the tank, not exceeding the max fill on your gas tank.
• Allow engine to cool before lling fuel tank.
• Do not overll because fuel could spill onto hot engine parts and ignite or
explode.
NOTICE
CAUTION
E
F
2
1