Pre Start Inspection and Operation
3.5
8. Grease pivot shafts with proper type of grease. There are 9 grease points on this machine,
see Figure 3–5.
Before starting the engine:
• Move all hydraulic control levers forward and release the lever. Make sure that
each lever automatically returns to the Neutral position.
• Move all hydraulic control levers rearward and release the lever. Make sure that
each lever automatically returns to the Neutral position.
• The Auxiliary Control Lever will remain in the Reverse position until it is
manually moved to the Neutral position.
• If any of the levers, other than the Auxiliary Control Lever, does not
automatically return to the Neutral position, DO NOT use the machine until
repairs have been completed.
CAUTION
To Next Page
Loading...
