ROTARY MOWER
1.6 STORAGE
If the machine is to remain idle for a long period of time, it
must be stored in a sheltered place, protected against
adverse weather conditions and covered to prevent dust
from building up.
Before it is stored, it is advisable to thoroughly clean all
parts of the machine and to adequately lubricate all the
mechanical components to protect them from rust.
- Pull out the bearing stand and set it in position;
- thoroughly wash the machine;
- generally inspect the machine to see whether there is any
structural damage or deep abrasions in the paintwork.
Make sure that all the safety decals are applied in their
original positions, that they are undamaged and legible;
- have any breakage, abrasions or damage repaired. Any
damaged decals should be immediately replaced;
- replace any broken or damaged protective covers with
genuine spares;
- grease all mechanical parts, the fastening pins and the
driveline coupling head (see SECTION 5 Maintenance);
- if possible, store the machine in a sheltered place and rest
it on wooden planks to keep it stable;
-cover the machine with a tarpaulin tied in place.
Recovered used oil must not be thrown away
indiscriminately. According to the current laws, it is classified
as special waste and as such, must be taken to special
disposal centers.
Contact your nearest authority.
1.7 DEMOLITION AND SCRAPPING
If the machine is scrapped, it must be disposed of in an
authorized dump. Comply with the local laws in merit.
- Recover any used oil and take it to an authorized center
for disposal.
- Separate the plastic or rubber parts and the electrical and
electronic materials before the machine is scrapped.
- The parts consisting solely of plastic, aluminium and steel
can be recycled if taken to the appropriate disposal centers.
A
B
D
Fig. 2
C
E
To Next Page
Loading...