User Guide - v11 19
• IP Address
• Netmask
• Default Gateway
• Primary Name Server
IndigoVision recommends that if you are using DHCP, you should configure the DHCP
server to assign a given IP address based on the device’s MAC address. Also, if the device
does not receive any response from the DHCP server it will default to using the network
parameters supplied by the last completed DHCP request.
If you are not using DHCP, you must enter the information manually.
• IP Address — Enter the IP address of the device.
• Netmask — Enter the IP network subnet mask.
Ensure that you enter the correct values. Once you change from the defaults, the device is no
longer configurable by the PC with its current network settings.
• Default Gateway — This is the appropriate default gateway for remote network
access.
• Primary Name Server — Enter the IPaddress of a primary (1) DNSserver.
If you have problems maintaining a network link, contact your system administrator to
determine the appropriate setting.
This setting must match the setting on the switch port that the device will be connected to.
Otherwise, you may experience poor network performance.
After you have entered the configuration data, click OK to apply the changes.
IndigoVision recommends that you make a note of the new IP address and subnet mask, or
label the device with its new details.
Ensure that no two devices share the same IP address (or that of the PC).
You must configure network settings before you can access the next unit for configuration.
HD Interceptor Camera - Specialized Range 3 Getting Started
To Next Page
Loading...
Need help?
General
