User Guide - v11 39
• Force Day Settings
• Disable Forced Settings
• Force Mono Settings
• Force HLC On / Off
• Iris Open / Close / Auto / Manual
• Power Low / On
Use Force ONVIF Configuration to specify the ONVIF configuration the camera reports:
• Reported Version - Change the ONVIF version reported by the camera.
• Preset Token Format - Specify the reported format of the preset token.
• Default: Uses a mix of text and ‘P’ zero-pad number as preset tokens.
• Number only: Uses numbers as preset tokens.
• ‘P’ zero-pad number: Uses P001 to P360 as preset tokens.
• Authorisation Elevation - Set the authorization to Default, Administrator, User or
Operator.
• Pan/Tilt Position Range - Set the angular position.
• Advertise Multicast - Advertise that the camera supports multicast using ONVIF.
• Auxiliary Functions - Select the range of auxiliary functions. Configurable, standard
and additional functions are available, as well as their combinations.
• Pre-defined Presets - Select one of the modes: Advertise All Defined, Advertise
Re-definable, Omit, or Advertise All.
• Iris Scale - Select one of the modes: Position or Attenuation (dB).
Add/Edit Users
Use this page to add additional administrators, operators, or viewers.
To add a new Administrator follow this procedure:
1. Type a Username.
2. Enter and confirm a password for the user.
3. Set the user's Authority to Administrator.
4. Select Add.
You cannot edit or delete the default Administrator.
Maintenance
This page allows you to perform the following actions:
• Versions
View firmware version.
• Parameters and Settings
Access backups and resets.
• Camera Maintenance
Reboot the camera and update firmware.
• Storage
View storage.
• NTP Calibration
Perform NTP calibration.
• Content Upload
Perform content upload.
HD Interceptor Camera - Specialized Range 5 Configuration
To Next Page
Loading...
Need help?
General
