28 User Guide - v11
Home Function
Use the Home Function to set the camera to perform an action after a period of inactivity.
Home Action
You can set a camera to a preset, tour or mimic after a period of inactivity.
Commands such as pan, tilt, and camera control will reset the home timer.
You can set Home Action to the following options:
• None (default)
• Preset
• Tour
• Mimic
Home Number
If Home Action is set to Preset, Tour or Mimic, Home Number can be set to one of the
following:
• Presets 1 to 360
• Tours 1 to 4
• Mimics 1 to 4
Home Timer
If Home Action is set to Preset, Tour or Mimic, you can set the home timer to one of the
following: 10s, 20s, 30s, 1m, 2m, 5m, 10m, 15m, 30m or 1h (default setting is 1 minute).
Wiper
Use Wiper settings to set the behavior of the camera’s screen wipers.
Wiper Rest Time
You can use Rest Time to set the time that the wiper will rest in the park position between
individual wipes.
You can set Rest Time to None (default) or between 1s and 15s.
Wiper On Time
You can use On Time to set the time that a wiper command remains ON before it
automatically turns OFF.
You can set On Time to Single (default), 5s, 10s, 30s, 1m, 5m, 10m, 30m, 1h or Permanent.
Use Single to set the wiper to perform a single wipe and then stop.
Use Permanent to set the wiper to remain ON until it is manually turned OFF.
Camera
This page is used for configuring the camera settings.
The top line of the page on the right of the screen shows the camera type and the maximum
optical zoom for the camera.
5 Configuration HD Interceptor Camera - Specialized Range
To Next Page
Loading...
Need help?
General
