User Guide - v11 27
Mimics
You can define mimics, or sets of actions which the camera repeats on command.
When you play a mimic, the camera repeats the mimic continuously until you stop it, or it is
interrupted by an alarm.
You can define up to four different mimics.
Select Start to start to define the mimic.
Move the camera, seek presets and/or control the lens to define the actions to be saved for
the mimic.
After the mimic is complete, select Stop to stop recording the mimic.
Select Play to start or stop the mimic that has been selected.
Tours
A tour of presets is stored in the camera as a list of tour points. A maximum of four individual
tours of presets can be stored in each camera.
Each tour point consists of a preset number, the dwell time for which the camera pauses and
the speed parameter that is used to seek the preset.
Each of the four tours of presets can contain between 1 and 90 points. Each point can be a
preset in the range 1 to 360.
When programming a tour of presets, first store all the required presets into the camera and
define the required dwell times and speeds of travel that you require the camera to use when
the tour is started.
Different points can use any preset number including repeats of ones that have been used
before. The speed that the camera travels at to reach the preset can be in the range 1
(slowest) to 100 (fastest). To seek the preset at the maximum speed, set speed to
Maximum.
The delay (dwell) at each point is defined in seconds (Range 1 to 100).
Select Add to add a new point to the tour.
Select Final to indicate that this point is the last in the tour.
Select Play to start or stop the tour that has been selected.
Privacy Zones
Up to 24 privacy zones can be displayed at the same time.
Use pan, tilt, and zoom to place the object that is to be obscured by the privacy zone in the
middle of the screen.
The privacy zone does not cover the whole of the screen which makes it easier to see the
object that will be obscured.
It may be necessary to redefine the privacy zone to ensure that the object will be obscured
properly or alternatively the privacy zone can be made to be twice the size of the object to
eliminate the need for fine adjustment.
Define the privacy zone using Define.
Enable (or disable) the privacy zone using Enable or Disable.
The position of the selected privacy zone can be checked by selecting Seek.
HD Interceptor Camera - Specialized Range 5 Configuration
To Next Page
Loading...
Need help?
General
