Motorola solutions IndigoVision Specialized Series User Manual

26 User Guide - v11
To enable simultaneous use of unicast and multicast streams, select Concurrent
Unicast/Multicast.
To change unicast stream limit, use the Unicast Stream Limit bar.
In the Configuration section, you can configure the following settings:
• IPRatio
Sets the codec’s required ratio of frames to an I frame.
If the camera is configured for the PAL region, the default is 25 frames.
If the camera is configured for the NTSC region, the default is 30 frames.
• RTP Block Size
Sets the size of the RTP (Real-time Transport Protocol) blocks.
• I Frame Size
Sets the size of the I Frames.
• Streamer Version
Lets you select the underlying video streaming library, the default is Original.
Select OK to apply the changes.
Advanced Features
Use this page for configuring presets and tours.
Presets
Each Preset (1 to 360) can have individual settings for the following:
The preset can be named (Maximum of 32 characters) using the text box. Click Define to
define the preset.
• Type - Choose from one of the following:
• Night - Allow different options to be used for a preset that includes lamps.
• Simple - Set the preset without lamp options.
• Wiper - Set the preset to activate the wiper.
• Washer - Set the preset to activate the washer.
• Re-Map - Choose which function/preset you want to re-map to the new preset
number above.
• Tour - Set the preset to start or stop a preset tour.
• Mimic - Set the preset to start or stop a mimic tour.
• User - Used on systems supporting 360 SDK.
• Auxiliary - Recall an auxiliary command.
• Illumination - IR (default), WHITE, NONE ‘Night Preset’
• Intensity - 100% (default), 80%, 60%, 40%, 20%, 0% ‘Night Preset’
• Sensor - MONO (default), COLOUR ‘Night Preset’
• Focus Range - IR (default), AMBIENT ‘Night Preset’
• PTZ - Enabled (default), Disabled always active
If Night Presets are turned ON and it is night time, setting the camera to seek to a preset
causes the Illumination, Intensity, Sensor, and Focus Range to change as defined.
When a seek to a preset occurs during the day, or the Night Presets are turned OFF and it is
night time, then Illumination, Intensity, Sensor, and Focus Range do not change.
The seek preset actions defined for PTZ occurs for all preset seeks and are not controlled by
the Night Preset parameter, and do not depend upon whether it is night time.
5 Configuration HD Interceptor Camera - Specialized Range

Motorola solutions IndigoVision Specialized Series Specifications

General

Brand	Motorola solutions
Model	IndigoVision Specialized Series
Category	Security Camera
Language	English