Motorola APX 1500 - Manually Refreshing the Remote Emergency List; Receiving Remote Emergency; Emergency Keep-Alive; Impact Detection

• Imbalance Coverage
If your radio receives acknowledgment, your radio displays a positive notification.
If your radio does not receive acknowledgment from the target radio, your radio displays a negative
notification.
9.8.3
Manually Refreshing the Remote Emergency List
Procedure:
1 Press the programmed Remote Emergency button.
2 To refresh the remote emergency list, press Rfsh.
Your radio displays List refreshed followed by the updated remote emergency list..
9.8.4
Receiving Remote Emergency
The remote emergency will only be launched if your radio has the emergency enabled. The receiving
radio displays Emergency.
Procedure:
To exit the emergency operation, press and hold the programmed Emergency button.
9.9
Emergency Keep-Alive
This feature prevents your radio from turning off when in Emergency mode. If this feature is enabled,
you are required to exit Emergency mode before turning off your radio.
9.10
Impact Detection
This feature activates Emergency mode when your radio detects an impact or orientation changes
on the vehicle in the event of a vehicle crash or rollover. Your radio automatically activates Impact
Detected condition when the impact event meets or exceeds a predefined threshold.
Your radio must stay in this condition for a programmed amount of time before the Emergency Alarm
or Call is activated. This feature sends out the location-based information if Global Positioning System
(GPS) is enabled.
Your radio indicates hardware failure or malfunction by alternatively displaying Impact HW and Error
along with a tone. Pressing any button of the radio besides the programmed button for volume and
backlighting functionality, or accessory stops the error message and sound.
The following scenarios affect the Emergency feature activation:
• Pressing a programmed Emergency button cancels the Impact Detection sequence and enters the
Emergency mode.
• Pressing the PTT button does not suspend the Impact Detection sequence.
• Pressing the PTT button, the Clr menu button, or the programmed Clear button when your radio
displays the Impact Detected display alert, exits the Impact Detected condition.
68012006035-FA
Chapter 9 : Emergency Operation
62