14.3.2.1
Searching and Pairing Bluetooth Devices
Prerequisites: Ensure that the Bluetooth and Bluetooth Visibility are turned on.
Procedure:
1 Press the BT menu item.
2 Select Search Devices and press On.
To stop the search before the search timer expires, you must press Stop.
3 Select the required device for pairing and press Sel.
14.3.2.2
Turning Bluetooth Visibility On or Off
Turning on Bluetooth visibility enables other Bluetooth devices to search for your radio. Bluetooth
visibility is turned off by default.
Procedure:
1 Press the BT menu item.
2 Select Visibility.
3 Perform one of the following actions:
• To turn on the Bluetooth visibility, press On.
• To turn off the Bluetooth visibility, press Off.
If the visibility mode is enabled, the display shows a positive notification.
When the timer expires, the display shows a negative notification. Repeat the procedure to turn on
Bluetooth visibility.
14.3.2.3
Receiving Pairing Request from Other Devices
When your radio receives a pairing request from other devices, the display shows <Device
Friendly Name> pair request.
Procedure:
Perform one of the following actions:
• To accept the pairing request, press Ok.
• To reject the pairing request, press Cncl.
14.3.3
PIN Authentication in Pairing
This feature allows your radio to verify the correct device to pair with using PIN authentication.
NOTE: The PIN authentication method is only applicable for Bluetooth version 2.1 and above.
68012006035-FA
Chapter 14 : Connectivity
77
To Next Page
Loading...
