2 Enter the old password.
3 Enter the new password.
4 To accept the entry, enter the new password again.
33.3
Viewing the List of Channel Parameters
Procedure:
1 Press the FPP menu item.
2 Perform one of the following actions:
• To view the unprotected FPP-Enabled zone list, press OK without entering the password.
• To view the entire FPP-Enabled zone list, enter the password and press OK.
NOTE:
If the current zone is FPP-Enabled, your radio displays the current zone. If the current
zone is not FPP-Enabled, your radio displays the unprotected FPP-Enabled zone in the
list first.
If unprotected FPP-Enabled zones are unavailable, such as all zones are protected,
pressing OK without entering the password generates a negative indicator tone and
remains in the get-password state.
3 To view the list of channels in the required FPP-Enabled zone, press VIEW.
4 To view the list of channel parameters that are FPP programmable, press VIEW again.
The first programmable channel parameter is shown.
33.4
Editing Channel Parameters
Prerequisites: Perform steps in Viewing the List of Channel Parameters on page 116.
Procedure:
1 Edit channel parameters by using the following options:
Option Actions
Editing Tx or Rx
a To find Tx or Rx, press the Left or Right
navigation button.
b To modify the Tx or Rx frequency of the
selected channel, press EDIT.
c Enter the required value.
Editing Tx PL or Rx PL
a To find Tx DPL or Rx DPL, press the
Left or Right navigation button.
b To modify the TX DPL or Rx DPL code of
the selected channel, press EDIT.
c Enter the required value.
Editing Tx DPL or Rx DPL
a To find Tx DPL or Rx DPL, press the
Left or Right navigation button.
68012006035-FA
Chapter 33 : Front Panel Programming
116
To Next Page
Loading...
