Motorola CP185 - Transmitter Alignment Options

5-4 Radio Programming and Tuning: Transmitter Alignment Options
5.5 Transmitter Alignment Options
Note: The maximum available power level given in the table below must NOT be exceeded.
There are separate alignment procedures for High and Low power.
Note:
When checking the RF power output of the radio with a test set, always use a pad of
at least 30 dB attached to the radio end of the RF cable. This will avoid an RF
mismatch and ensure a stable RF reading that will not change with varying lengths of
connecting cable.
Table 5-2. Transmit High/Low Power Level
RF Band (MHz) Model Number
High Power
(W)
Low Power
(W)
136 – 174M 5W 12.5/25K 16C AAH03KEF8AA7_N 5.00 – 5.30 2.00 – 2.30
136 – 174M 5W 12.5/25K 16C NKP AAH03KEC8AB7_N 5.00 – 5.30 2.00 – 2.30
136 – 174M 5W 12.5K 16C NKP AAH03KEC4AB7_N 5.00 – 5.30 2.00 – 2.30
136 – 174M 5W 12.5/25K 16C LKP AAH03KEF8AB7_N 5.00 – 5.30 2.00 – 2.30
136 – 174M 5W 12.5K 16C LKP AAH03KEF4AB7_N 5.00 – 5.30 2.00 – 2.30
136 – 174M 5W 12.5/25K 99C FKP AAH03KEK8AB9_N 5.00 – 5.30 2.00 – 2.30
403 – 447M 4W 12.5/25K 16C NKP AAH03QDC8AB7_N 4.10 – 4.35 2.05 – 2.25
403 – 447M 4W 12.5/25K 99C LKP AAH03QDH8AB7_N 4.10 – 4.35 2.05 – 2.25
403 – 447M 4W 12.5/25K 99C FKP AAH03QDK8AB9_N 4.10 – 4.35 2.05 – 2.25
435 – 480M 4W 12.5/25K 16C AAH03RDF8AA7_N 4.10 – 4.35 2.05 – 2.25
435 – 480M 4W 12.5/25K 16C NKP AAH03RDC8AB7_N 4.10 – 4.35 2.05 – 2.25
435 – 480M 4W 12.5K 16C NKP AAH03RDC4AB7_N 4.10 – 4.35 2.05 – 2.25
435 – 480M 4W 12.5/25K 16C LKP AAH03RDF8AB7_N 4.10 – 4.35 2.05 – 2.25
435 – 480M 4W 12.5K 16C LKP AAH03RDF4AB7_N 4.10 – 4.35 2.05 – 2.25
435 – 480M 4W 12.5/25K 99C FKP AAH03RDK8AB9_N 4.10 – 4.35 2.05 – 2.25